CNCezPRO™ Software

Real-Time 3D Graphics Simulation for Computer Numerical Control



G42 TOOL NOSE RADIUS COMPENSATION RIGHT
N_ G42
The G42 command applies cutter compensation to the right hand side of the programmed tool path. This amount is equal to the current tool's nose radius value, which is stored in the Tool Offset Register table of the controller.
Example G42
% (PROGRAM START FLAG)
:1042
N5 G20 G40
N10 T0101
N15 M03
N20 G00 Z0.1 M08
N25 X1.75
N30 G01 Z-2 F0.012
N35 G00 X2 Z0.1
N40 X1.5
N45 G01 Z-1.5
N50 G00 X1.75 Z0.1
N55 X1
N60 G01 Z0
N65 G03 X1.5 Z-0.25 I0 K-0.25
N70 G00 X4 Z3 T0100
N75 G00 T0202
N80 G42 G00 X0
N85 Z0.1
N90 G01 Z0
N95 X1
N100 G03 X1.5 Z-0.25 R0.25
N105 G01 Z-1.5
N110 X1.75
N115 Z-2
N120 X2.1
N125 G40 G00 X4 Z3 M09
N130 T0200 M05
N135 M02